Pelpro TSC90 - Troubleshooting; Power and Response Issues; Component Failure Diagnosis

PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com22
Troubleshooting
Troubleshooting
Power Related
In the event of a power outage:
• If using a generator, Pelpro recommends
a steady state generator for best stove
performance.
• This stove needs 110v to run properly. This stove
has not been tested for use with a third party
battery backup.
Stove plugged in but no response
• Check your home’s circuit breaker
• Reset snap disc (located between drop tube and
hopper (Zone 2)
• Visually inspect wires, blowers and power cord
for breaks or wear to nd cause of possible short
circuit (Zone 2)
Component (i.e. blower) fails to start or fails to
turn off
• Check all connections and power plugs are secure
• Visually inspect wires, blowers and power cord to
nd cause of possible short circuit



Pro Tip
Check passages to assure
they are clear of ash and
obstructions. Poor airow
leads to poor performance
of your stove.
Troubleshooting your stove
Visit pelprostoves.com or scan this code:
A
A
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone