Pelpro TSC90 - What Youll Need; Pellet Vent Pipe Requirements; Floor Protection & Fuel Selection

PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 5
Getting Started
Getting Started
What You’ll Need
Tools & Supplies
• High temperature silicone
(500°F+)
• Level
• Phillips screwdriver
• Plumb line
• Tape measure
• Framing square
• Reciprocating saw
• Electric drill & bits
• Caulking gun
• Stud nder
• Utility knife
• Pliers
• Flashlight
• Hammer
Safety Equipment
Recommended for all installation and maintenance steps.
Pellet Vent Pipe
Must be an approved 3” or 4” diameter Type “L” or “PL” vent. Use 4” diameter vent if ue height
is over 15’ or if installation is over 3,000 ft. above sea level.
Floor Protection
Non-combustible material
(such as a hearth pad) is
required underneath your
stove.
Surge Protector
Protect the electrical
components of your stove
by using a surge protector.
Pellet Fuel
Use only wood pellets
in your stove. For best
performance, use
premium, low-ash pellets
(<1%) less than 1.5” in
length and avoid the dusty
bits and pieces of pellets
in the bottom of the bag.
WARNING!
Fire Risk. NO OTHER vent components may be used. Substitute or damaged vent components may
impair safe operation.
Gloves Safety Glasses Close-toed shoes