Pelpro TSC90 - Getting Started; Pallet Removal; Whats Included

PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com4
Getting Started
WARNING!
Inspect appliance and components for damage.
Damaged parts may impair safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to consumer care.
Getting Started
Pallet Removal
There are bolts holding your PelPro stove in place
on the pallet. To remove your stove from the pallet:
What’s Included
1 2
Using a 3/8” wrench,
remove each bolt by
reaching under your
stove. Tip your stove
to opposite side and
push bracket inward;
set stove down and
repeat on other side.
Using a 7/16” wrench,
remove all four bolts
attaching the shipping
bracket to pallet.
Owner’s
manual
Door handleCleaning tool Power cord
Pallet Removal
Visit pelprostoves.com
or scan this code.
Outside air kit
components:
2” Flex hose Termination Cap Hose clamp Screws (4)
CAUTION!
Risk of cuts, abrasions or ying debris. Wear
protective gloves & safety glasses during install.
Metal edges are sharp.
Online Installation &
Trouble Shooting Videos