8” Model
10” Model
Closed
Closed
17 1/2”
(44.5 cm)
12 1/4”
(31.1 cm)
20 1/4”
(51.4 cm)
14”
(35.6 cm)
19 1/4”
(48.9 cm)
24 5/8”
(62.5 cm)
PRODUCT INFORMATION
Specifications
Exterior Dimensions
8” Model-
12 1/4” high x 20 1/4” deep x 17 1/2” wide
(31.1 cm high x 51.4 cm deep x 44.5 cm wide)
10” Model-
14” high x 24 5/8” deep x 19 1/4” wide
(35.6 cm high x 62.5 cm deep x 48.9 cm wide)
Chamber Dimensions
8” Model-
8 7/32” inside diameter x 14” useable depth
(21 cm inside diameter x 35.6 cm deep)
10” Model-
9 7/8” inside diameter x 17 7/16” useable depth
(25.1 cm inside diameter x 44.3 cm deep)
Weight Without Water in Reservoir
8” Model-
61 lbs. (28 kg)
10” Model-
84 lbs. (38 kg)
Power Supply
Both Models-
110 - 120 Volts, 50/60 Hz or
220 - 240 Volts, 50/60 Hz
Measurement
Pressure: +/- 8 kPa (1.16 PSI or .08 bars)
Temperature: 3.6° F (2° C)
Time: +/- 1 second
Nominal Current Consumption
8” Model-
12 Amperes @115 Volts /
6 Amperes @230 Volts
10” Model-
16 Amperes @115 Volts /
8 Amperes @230 Volts
Environmental and Storage Limitations
Both Models-
Optimum Operating Temperature Range:
50°F to 104°F
(10°C to 40°C)
Relative Humidity Range:
30% to 75%
Optimum Storage Temperature Range:
-40°F to 158°F
(-40°C to 70°C)
Unit is designed for normal dental/medical office environment.
NOTE: If printer is used, its operating temperature is 41°F to 95°F
(5°C to 35°C).
Mode of Operation:
Both Models- Continuous
NOTICE: Manufacturer will make available all information which will
assist the authorized service representative to repair equipment.
Calibration of the power board is to be done only at the factory.
To Next Page
Loading...
