- 23 - Hardware Installation
Relion 2908GT Chassis Manual
6 Installing the PCI Expansion Card
• Voltages can be present within the server whenever an AC power source is connected. This
voltage is present even when the main power switch is in the off position. Ensure that the system
is powered-down and all power sources have been disconnected from the server prior to installing
a PCI card.
Failure to observe these warnings could result in personal injury or damage to equipment.
For GPU0/GPU1/GPU6/GPU7
Follow these instructions to install PCI Expansion card:
1. Loosen and remove the screws securing the PCI cage.
2. Pull the two plastic handles to lift up the PCI cage from the system.
3. Insert the card into the selected slot and secure the expansion card with screw.
Make sure that the card is properly seated.
4. Secure the PCI expansion cards in place with screws.
Front Rear
Top: GPU Card #6 (Slot 1)
Bottom: GPU Card #7 (Slot 2)
Top: GPU Card #0 (Slot 1)
Bottom: GPU Card #1 (Slot 2)
1
2
2
1
To Next Page
Loading...
