Penguin Computing Relion 2908GT - Rear System Button and Leds

Hardware Installation - 41 -
Relion 2908GT Chassis Manual
3-4 Rear System Button and LEDs
1
2 3 5 6
4
7
No. Name Color Status
Critical
Description
Event
Power button
1. and LED
Green Solid On N/A System is powered on
Green Blink N/A System is in ACPI S1 state (sleep mode)
N/A Off
• System is not powered on or in ACPI
S5
state (power off)
N/A
• System is in ACPI S4 state
(hibernate mode)
ID Button
2.
and LED
Blue Solid On N/A System identification is active.
N/A Off N/A System identification is disabled.
3. Reset Button Press the button to reset the system.
4. NMI button
Press the button server generates a NMI to the
processor if the multiple-bit ECC errors occur,
which effectively halt the server.
System
5.
Status LED
Green Solid On N/A Running or normal operation
Amber Solid On
There is at least one sensor that has critical
alter.When the LED is solid on, check the
following:
Yes • Power module failure
• System fan failure
• Power supply voltage issue
• System temperature/voltage issue
N/A Off N/A System is not ready.
LAN1 Active/
6.
Link LED
Green Solid On
Link between system and network
N/A
or no access
Blink N/A Data transmission or receiving is occurring
N/A Off
N/A No data transmission or receiving is occurring
LAN2 Active/
7.
Link LED
Green Solid On
Link between system and network
N/A
or no access
Blink N/A Data transmission or receiving is occurring
N/A Off
N/A No data transmission or receiving is occurring