EasyManua.ls Logo

Penlon Prima 465 - Technical Alarms

Penlon Prima 465
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Prma 465 Anaesthetc Machne 67 User Manual
Operating the Anaesthesia System
Message Prorty ause Acton
EtHAL LOW
Medum EtAA s less than alarm lmt
heck the fll level of the vaporzers
Set alarm lmt approprately
heck agent settng
EtENF LOW
EtISO LOW
EtSEV LOW
EtDES LOW
FNO LOW Medum FNO s less than alarm lmt
Set the requred alarm lmts
heck the NO settng
Mxed Agent and MA > =3 Medum
Two dfferent agents are detected
and the MA calculaton s greater
than or equal to 3
Make sure only one vaporzer s on
Wat approxmately two mnutes for the
frst agent to wash out of the system
Mxed Agent and MA < 3 Low
Two dfferent agents are detected
and the MA calculaton s less
than 3
Make sure only one vaporzer s on Wat
approxmately two mnutes for the frst
agent to wash out of the system
6.12.6 Technical alarms
Message Prorty ause Acton
O SUPPLY DOWN Hgh
O ppelne pressure s less than
280 kPa
heck the O ppelne and cylnder are
properly connected
BATTERY DISHARED Hgh
Remanng battery power s
between fve and ffteen mnutes
Plug n the power cable
heck that the system crcut breaker s
on
EM FAILURE  Hgh Electronc gas mx hardware error
Swtch to alternate O control
Restart anaesthetc workstaton
ontact your servce personnel
EM communcaton falure Hgh Hardware error
Restart anaesthetc workstaton
ontact your servce personnel
BDU communcaton falure Hgh
Breath delvery unt hardware
error
Restart anaesthetc workstaton
ontact your servce personnel
as Module Software Error Hgh as Module Software Error ontact your servce personnel
as Module Hardware Error Hgh as Module Hardware Error ontact your servce personnel
as Module Motor Overspeed Hgh as Module Motor Overspeed ontact your servce personnel
as Module Factory calb lost Hgh as Module Factory calb lost ontact your servce personnel
as Module Replace Adapter Hgh as Module Replace Adapter ontact your servce personnel
as Module No Adapter Hgh as Module No Adapter ontact your servce personnel
O Unspecfed Accuracy Hgh O Unspecfed Accuracy ontact your servce personnel
NO Unspecfed Accuracy Hgh NO Unspecfed Accuracy ontact your servce personnel
AA Unspecfed Accuracy Hgh AA Unspecfed Accuracy ontact your servce personnel
as Module Temp Out Of
Range
Hgh as Module Temp Out Of Range ontact your servce personnel
Pressure Out Of Range Hgh Pressure Out Of Range ontact your servce personnel
AA ID Unrelable Hgh AA ID Unrelable ontact your servce personnel
BATTERY LOW Hgh
Remanng battery power s
between ten and thrty mnutes
Plug n the power cable
heck that the system crcut breaker s
on

Table of Contents

Related product manuals