PennBarry Fumex - OPTIONS & ACCESSORIES; Control Options; Other Accessories

www.PennBarry.com 7
Spare Belt
One or two extra sets of spare belts are available for selection.
iQ Controllers
There are two types of iQ controllers available:
• iQ-IPCM (Intelligent Pressure Control Module), with Duct Sentry™ technology is designed to maintain constant pressure 24/7 within
a duct system by controlling fan motor speed
• iQ-MS (Multi-Speed Controller), with dual set-point interface allows the user to set and remotely switch among two dierent motor
speeds.
Both of them provide motor control signal output of 0-10 VDC for seamless integration with today’s advanced motor technologies to
provide substantial energy savings and peace of mind.
Extend Lube Lines
Preloaded at the factory, lube lines allow bearing maintenance when easy access to the bearings is unavailable.
Stainless Steel Hardware
If another material is desired for the unit’s hardware, stainless steel hardware is available for selection.
Variable Frequency Drives
Variable frequency drives (VFDs) are designed to meet performance requirements while increasing eciency. By varying the fan
motor input frequency and voltage, the VFD controls the motor speed and torque, helping to improve productivity and lower energy
consumption. The VSC and VSA are ideal for both new and retrot fan applications. Shipped loose and separately.
0-10 Output Potentiometer
Potentiometers are always paired with Green Plus motors. With the potentiometer, the Green Plus motors can be turned down to as low
as 80% the max operating speed while maintaining 90% eciency through the operating range. Additionally, the Green Plus can accept
0-10V input to tie to building management systems, not only allowing for savings in direct fan energy consumption but reducing the
exhaust of conditioned air during o peak hours as well
Stainless Steel Shaft
If another material is desired for the motor shaft, stainless steel shafts are available for selection.
Transformers
To meet local requirements 277V transformers are available for all direct drive units. The transformers are step-down and will step the
voltage down to 120V. Shipped loose for eld installation.
Finishes
Coatings such as Polyester Powder Coat, Epoxy Powder Coat, Phenolic Epoxy Powder Coat, and others are available. See the coatings
brochure for details.
OPTIONS & ACCESSORIES