Why is Pentair Pool Products Swimming Pool Vacuum Legend falling over?
If your Pentair Pool Products Swimming Pool Vacuum Legend is falling over or lying on its side, it typically indicates that the debris bag needs emptying. Also, check the ballast float for leaks by unscrewing it counter-clockwise and listening for water inside.
What to do if Pentair Pool Products Swimming Pool Vacuum Legend will not back up?
If your Pentair Pool Products Swimming Pool Vacuum Legend isn't backing up, verify that the Back-Up Valve is cycling correctly by holding the valve out of the water to see if the jet comes on for approximately 30 seconds and shuts off for about 3 minutes and 30 seconds. Also, check the wheel RPM and empty the debris bag if it's full or even half full.
How to fix Pentair Pool Products Swimming Pool Vacuum Legend hoses tangling?
To resolve tangling hoses on your Pentair Pool Products Swimming Pool Vacuum Legend: * Check the length of the Feed Hose to ensure it is not too long. * Make sure the Feed Hose is floating properly on the surface and that the hose floats are evenly spaced. * Twist the Hose Swivels to ensure they spin freely; replace any that do not. * Lay the Feed Hose straight in the sun to remove any memory.
What to do if Pentair Pool Products Swimming Pool Vacuum Legend will not climb?
If your Pentair Pool Products Swimming Pool Vacuum Legend isn't climbing, even if algae isn't visible, brush the sides of the pool wall. Check the wheel RPM. Reposition the Thrust Jet by loosening the two screws to adjust it. Remember that the climbing ability depends on the pool's shape and water pressure; it climbs better in pools without sharp angles or curves where the floor meets the wall.
How to stop Pentair Pool Products Swimming Pool Vacuum sweep hose being sucked into the cleaner?
To prevent the sweep hose from being sucked into the cleaner of your Pentair Pool Products Swimming Pool Vacuum, adjust the Sweep Hose using the Adjustment Screw located on the bottom of the Swivel Mast, just below the upper Thrust Jet. Turn the Adjustment Screw clockwise until the Sweep Hose moves in a gentle sweeping motion.
Why is Pentair Pool Products Swimming Pool Vacuum booster pump very noisy?
If your Pentair Pool Products Swimming Pool Vacuum booster pump is very noisy: * Ensure the Wall Fitting is correctly mounted in the pool wall. * Verify that the Pool Filtration system is functioning properly. * Contact your local Pool Professional, as there might be a Booster Pump problem.
What to do if Pentair Pool Products Swimming Pool Vacuum sweep hose sprays water?
If the Sweep Hose of your Pentair Pool Products Swimming Pool Vacuum breaks the water surface and sprays nearby areas, adjust the Sweep Hose to ensure it moves in a gentle sweeping motion. You may also consider adding an optional Sweep Hose weight.
General| Brand | Pentair Pool Products |
|---|---|
| Model | LEGEND |
| Category | Swimming Pool Vacuum |
| Language | English |
To Next Page
