Pentair Flotec E75STVT User Manual (English)

Questions and Answers:

D
Dana MorganJul 29, 2025
What to do if my Pentair Flotec E75STVT Water Pump fails to operate?
- J
  Jacqueline StoneJul 29, 2025
  If your Pentair Water Pump isn't working, start by ensuring the power cord is securely plugged into the outlet. Disconnect power before handling the pump or motor. Also, verify that you have electrical power and the liquid level is high enough to activate the switch or controller. Check that the 3/16” (4.7mm) vent hole in the discharge pipe isn't blocked, and inspect the pump inlet, impeller, check valve, and discharge pipe for any blockages. If the thermal overload tripped, disconnect the power source for 30 minutes to allow the motor to cool, then reconnect it. Finally, check the float switch operation for maximum possible clearance.
B
Bill JohnstonAug 8, 2025
Why is my Pentair Water Pump not emptying the sump?
- C
  chenrobinAug 8, 2025
  If your Pentair Water Pump isn't emptying the sump, make sure all valves in the discharge valve are fully open. Clean out the discharge pipe and check valve to remove any obstructions. Inspect the pump inlet and impeller for blockages. If the pump is not sized properly, a higher capacity pump may be required. Also, check the float switch operation for maximum possible clearance.
C
Cassidy McdonaldAug 18, 2025
How to fix a Pentair Flotec E75STVT Water Pump that will not shut off?
- K
  kempchristopherAug 18, 2025
  If your Pentair Water Pump won't shut off, check the switch or controller automatic floats for proper operation, location, and clearance. Refer to the installation instructions for the switch/controller for guidance.