2
1
4
3
7
5
6
FRESHPOINT® EASY FLOW UNDER COUNTER
WATER FILTRATION SYSTEM
FILTER REPLACEMENT INSTRUCTIONS
1. Shut off the cold water to your faucet by turning
cold-water valve, under the sink, clockwise.
2. Turn on cold water faucet to release pressure
and to drain water from hose.
3. Press and hold Filter Release Button while holding rmly
on the base. Pull up on the exhausted lter to remove.
4. Insert the new lter into base of the FreshPoint
Easy Flow Water Filtration System. An audible
click ensures proper sealing of the lter.
5. Open water shutoff valve by turning counter-clockwise.
6. Allow water to ow with faucet open completely
for fteen (15) minutes to ush the lter.
NOTE: A drinking water lter may contain carbon nes
(very ne black particles). If carbon nes appear in
the water, continue ushing until none are present.
NOTE: Initially, ltered water may appear cloudy.
If cloudiness in glass of water rises to the top, the cause
is likely due to air in the water. The air (and cloudiness)
will disappear within a few weeks after installation.
7. Press and hold small Filter Life Indicator Button for ve
(5) seconds. A blue light on the Filter Life Indicator will
ash four (4) times to conrm timer has started.
4007514 Rev A NV20
13845 Bishops Dr. | Suite 200 | Brookeld, WI 53005 | United States
P: 262.238.4400 | Customer Service: 800.279.9404 | tech-support@pentair.com | pentair.com
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
© 2020 Pentair. All rights reserved.
13845 Bishops Dr. | Suite 200
Brookeld, WI 53005 | United States
P: 262.238.4400 | Customer Service: 800.279.9404
tech-support@pentair.com | pentair.com
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and
unregistered trademarks and logos are the property of their respective owners.
© 2020 Pentair. All rights reserved.
To Next Page
