GLOBRITE™ Color Changing LED Pool /Spa Light Installation and User’s Guide
10
6. Place the light installation tool (P/N 620057) over the front of the light. Turn
the tool and light clockwise (less than an 1/8th. turn), while pushing inward,
until you feel the stop point. This indicates the light is properly seated,
locked and the niche is completely sealed.
Note: If the light does not turn smoothly, pull the light slightly out and make
sure that it’s seated properly and the niche is free of debris, then install the
light as described in step 6.
7. Before operating the GloBrite color light, fill the pool with water until the
light is completely submerged.
Note: The GloBrite color light should not be powered for more than 30
seconds if is not submersed in water.
8. Final check for proper GloBrite light operation: Switch on the main switch
or circuit breaker to the 12 VAC transformer and the switch that operates
the GloBrite light itself. The light should illuminate when the 12 VAC power
is applied. If not recheck the installation steps.
GloBrite
™
Color Light Installation/Removal Tool
Align and insert tool pins with holes
in front of light
Rotate handle 1/8
turn clockwise to
install or counter-
clockwise 1/8 turn
to remove
Light installation
and remove tool
To Next Page
Loading...
