What to do if Pentair Underwater lighting is not working?
If your Pentair Underwater light isn't illuminating, start by checking the GFCI ground fault wiring and reset it if needed. Inspect the light wiring connection at both the poolside junction box and the AC power switch. Make sure the light is receiving proper AC power.
What to do if LEDs are flashing on Pentair Underwater lighting?
If both LEDs are flashing on your Pentair Underwater lighting, it means the IntelliBrite Controller has detected that the load has exceeded the maximum allowable wattage or the output is shorted out. To resolve this: 1. Switch the IntelliBrite Controller OFF and remove the excessive load or short. 2. Then, press the IntelliBrite Controller power switch to power on the unit. Make sure the LEDs are no longer flashing.
Details risks of electrical shock, electrocution, and installation requirements by qualified personnel.
Specifies pool placement relative to electrical sources and GFCI protection requirements.
Outlines responsibilities and code compliance for installers and inspectors.
Guidance on using transformers for multiple 12 VAC GloBrite lights and cable length.
Details maximum allowable wattage for multiple LED lights with a 300W transformer.
Explains manual control via a wall switch, cycling power for modes/colors.
Details how to select light shows or fixed colors by cycling the wall switch.
Describes how to control lights using the IntelliBrite controller, including dial selection.
Step-by-step guide for installing the niche sleeve and cone in concrete/gunite pools.
Step-by-step guide for installing the niche in a fiberglass pool wall.
Procedures for installing the niche in a vinyl liner pool.
How to connect and seat the GloBrite light assembly into the installed niche.
Instructions for removing and installing a replacement GloBrite light assembly.
Detailed steps for wiring the GloBrite lights to an EasyTouch/IntelliTouch control system.
Diagram and instructions for connecting GloBrite lights via an IntelliBrite controller and transformer.
Common issues and solutions for GloBrite color lights not illuminating or functioning correctly.
Lists available GloBrite lights, bundles, niches, and replacement parts with part numbers.
General| Lens | Polycarbonate |
|---|---|
| Type | LED |
| Beam Angle | 120 degrees |
| Light Source | LED |
| Certification | UL Listed |
| Voltage | 12V |
| Color Options | White |
| Cord Length | 50 ft |
To Next Page
