KREEPY KRAULY
®
PLATINUM
™
INSTALLATION MANUAL
3. Checking Wheel RPM
To determine whether the Kreepy Krauly
®
Platinum
™
is receiving the proper water pressure, turn off the
booster pump, pool pump and carefully remove the
Kreepy Krauly
®
Platinum
™
from the pool.
Mark the front drive Tire/Wheel with a marker, or use
the Logo located on the side of tire as a marker to
count the rotations of the wheel per minute.
Have someone turn on pool pump and then booster
pump while you place the Kreepy Krauly
®
Platinum
™
in the pool just beneath the water surface. (Be sure
to hold onto the Sweep Hose to avoid getting wet).
Count the rotations of the marked wheel for exactly
one minute. (Be sure the Back-Up Valve isn't cycling
at this time). The rotations will give you the
Revolutions Per Minute, (RPM).
For proper performance, the Kreepy Krauly
®
Platinum
™
operates between 28-32 RPM. If the RPM
is below 28 then call your local Pool Professional
or contact our Technical Support Department at
1-800-831-7133.
If the RPM is more than 32, at the Wall Fitting
unscrew the Pressure Valve slowly until the RPM
falls between 28-32.
If you have any additional questions, please
contact our Technical Support Department @
1-800-831-7133.
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the
Kreepy Krauly
®
Platinum
™
Turn off booster pump and pool pump. Then take the
Wall Fitting and twist lock the Wall Fitting clockwise
into the Wall Adapter. To disconnect the Kreepy
Krauly
®
Platinum
™
, unlock and twist counter
clockwise. The Wall Adapter should remain in the
pool wall.
B. Turning On/Off the Kreepy Krauly
®
Platinum
™
The Kreepy Krauly
®
Platinum
™
operates off the
booster pump coming from the equipment pad, and
can be turned on or off by merely turning on/off your
booster pump time clock.
8
To Next Page
Loading...
