Pentair Kreepy Krauly Prowler 930 - User Manual

Pentair Kreepy Krauly Prowler 930

20 pages

To Next Page

To Next Page

Loading...

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

KREEPY KRAULY

®

PROWLER

®

930

ROBOTIC INGROUND POOL CLEANER

INSTALLATION AND

USER’S GUIDE

Questions and Answers:

J
Jessica ChavezAug 1, 2025
Why is my Pentair Swimming Pool Vacuum not climbing walls?
- K
  Kathleen WatsonAug 2, 2025
  If your Pentair Swimming Pool Vacuum isn't climbing walls, it could be due to several reasons. Try cleaning and washing the cartridge, as the cleaner might be too heavy. Brush the walls to remove algae. Ensure the water temperature is ideal, between 54-90° F (12-32° C). If the brushes are worn, consider replacing them. Check for and remove any debris around the impeller. Turn the cleaner upside down underwater to release trapped air, which can make it too light. Lastly, verify that the pH level is between 7.4 - 7.8, with a minimum of 7.2.
M
mjamesAug 6, 2025
How to fix Pentair Swimming Pool Vacuum that does not reach all areas of the pool?
- J
  John WarrenAug 6, 2025
  If your Pentair Swimming Pool Vacuum isn't reaching all areas, it might be due to the power supply being incorrectly positioned. Ensure it's placed so the cleaner can reach all walls. If the cleaner isn't climbing walls, check the reasons for that issue. Brush the pool walls and floor to remove algae. Also, turn off the pool filter and pump and run another cleaning cycle.
M
mholderAug 12, 2025
What to do if Pentair Swimming Pool Vacuum is moving in circles?
- W
  Wendy SummersAug 12, 2025
  If your Pentair Swimming Pool Vacuum is moving in circles, it could be due to dirt stuck in moving parts; remove any dirt. Worn tracks could also be the cause, in which case you should replace them. Ensure the power supply is positioned so that the cleaner can reach all walls. Algae in the pool can also cause this issue, so correct the pool and water conditions.
B
Brooke FieldsAug 16, 2025
What to do if Pentair Swimming Pool Vacuum will not sink?
- L
  Larry GibsonAug 16, 2025
  If your Pentair Swimming Pool Vacuum will not sink, it could be due to air trapped inside. Turn the cleaner upside down underwater to remove trapped air. Wash the cartridge. Remove any calcium deposits or other chemical sediments. Open the inlet flap in the bottom lid to remove dirt and/or trapped air.
H
Henry LawsonAug 22, 2025
What to do if the power supply light is not working on Pentair Swimming Pool Vacuum?
- K
  Kylie RoseAug 22, 2025
  If the power supply or power supply switch light on your Pentair Swimming Pool Vacuum is not working, it might not be plugged in properly, or the main socket could be damaged. Reconnect it and check the main power supply.
J
Jessica RichardsonAug 27, 2025
Why is the cable on my Pentair Swimming Pool Vacuum twisting or coiling up?
- D
  deanna45Aug 27, 2025
  If your Pentair Swimming Pool Vacuum cable is twisting or coiling up, it could be due to an obstruction in the pool; remove any obstructions. If it's getting stuck on the main drain cover, turn off the filter and install a main drain cover ring. Excess cable in the pool can also cause this, so straighten the cable, lay it in the sun periodically, and remove any excess cable from the pool.

Pentair Kreepy Krauly Prowler 930 Specifications

General

Type	Robotic Pool Cleaner
Cable Length	60 feet
Pool Surface Compatibility	All pool surfaces
Pool Type	In-ground
Remote Control	Yes
Warranty	2 years
Cleaning Cycle	2.5 hours
Brush Type	Scrubbing Brush

Summary

Important Warning and Safety Instructions

Consumer Information and Safety

Guidelines for safe operation and maintenance of pool cleaners.

Risk of Electrical Shock or Electrocution

Warning about electrical hazards and GFCI requirements.

Hazardous Suction

Warning about suction hazards and entanglement risks.

Pre-Installation Check List

Steps to check before installing the cleaner.

Before installing the cleaner in a vinyl liner pool

Before installing the cleaner in a gunite pool or a pool that is partially or completely tiled

Preparation of the Pool and Cleaner

Cleaner Features

Initial Setup

Provides step-by-step instructions for the initial setup of the cleaner.

Caddy Assembly

Instructions for assembling the cleaner's caddy.

Operation

Control Panel Overview

Weekly Timer Feature

Setting the Weekly Timer

Cleaning Speed (Quick Clean Feature)

Explains how to use the Quick Clean feature for faster cleaning.

Delayed Start Feature

Bluetooth Wireless Technology

Maintenance

Removing the Cleaner from the Pool

Step-by-step guide on how to safely remove the cleaner from the pool.

Cleaning the Filter Baskets

Instructions for cleaning the inner and outer filter baskets.

Periodic Filter Screen Cleaning

Guide for dismantling and cleaning the four filter screens monthly.

Cleaning the Impeller

Instructions for removing debris trapped in the cleaner's impeller.

Storing the Cleaner

Related product manuals

Preview: KREEPY KRAULY PROWLER 920

KREEPY KRAULY PROWLER 920

Preview: KREEPY KRAULY PROWLER 820

KREEPY KRAULY PROWLER 820

KREEPY KRAULY PROWLER 830

Preview: Pentair Kreepy Krauly Platinum

Pentair Kreepy Krauly Platinum

Preview: Pentair KREEPY KRAULY

Pentair KREEPY KRAULY

Preview: Pentair KREEPY KRAULY WARRIOR

Pentair KREEPY KRAULY WARRIOR

Preview: Pentair kreepy krauly kruiser

Pentair kreepy krauly kruiser

Preview: Pentair KREEPY KRAULY E-Z VAC

Pentair KREEPY KRAULY E-Z VAC

Preview: Pentair KREEPY KRAULY LIL SHARK

Pentair KREEPY KRAULY LIL SHARK

Preview: Pentair Kreepy Kruiser

Pentair Kreepy Kruiser

Preview: Pentair REBEL

Preview: Pentair pool cleaner

Pentair pool cleaner