Pentair Kreepy Krauly Prowler 930 - Maintenance; Removing the Cleaner from the Pool

7
KREEPY KRAULY
®
PROWLER
®
930 Robotic Inground Pool Cleaner Installation and User’s Guide
Removing the Cleaner from the Pool
The cleaner will shut off automatically at the end of a cleaning cycle. Follow the steps below
to remove the cleaner from the pool.
1. Disconnect the power supply cable from the electrical outlet and disconnect the
cleaner communication cable from the power supply.
2. Using the cleaner’s communication cable, slowly and gently pull the cleaner to the
waterline at the edge of the pool until you can reach the handle. DO NOT lift the
cleaner out of the water by the cable.
3. Using the handle, lift the cleaner out of the pool. See Figure 17.
Note: Never lift the cleaner out of the pool by the communication cable. This puts an
unnecessary strain on the cable and could result in damage to the cleaner.
4. Place the cleaner on the edge of the pool and allow excess water to drain from the
cleaner body and basket. See Figure 18.
5. Disconnect the communication cable from the power supply.
6. If caddy is included, store the cleaner in the caddy with communication cable coiled
when not in use.
If not using a caddy, store the cleaner in a covered area with the communication cable
coiled.
MAINTENANCE
Ensure the power supply is turned “OFF” and disconnected from the electrical source/outlet
before removing the cleaner from the pool. Operating the cleaner out of water will immediately
cause severe damage and will result in loss of warranty. Do not leave the cleaner in the pool all the time.
Figure 17
Figure 18
LED Indicator Lights
The Prowler
®
930 Robotic Pool Cleaner includes an LED indicator just
above the scrubber on the front side of the cleaner (see Figure 16).
During normal operation powered by the power supply the LED indicator
will blink blue.
LED
Indicator
Figure 16
Make sure the cleaner’s power supply is turned “OFF” and is disconnected from the electrical source/outlet before servicing
the cleaner. Moving parts may injure hands or fingers if cleaner inadvertently powers on during servicing.