Pentair Kreepy Krauly Prowler 930 - Storing the Cleaner

11
KREEPY KRAULY
®
PROWLER
®
930 Robotic Inground Pool Cleaner Installation and User’s Guide
Storing the Cleaner
Any time the cleaner will not be in use for an extended period of time, for
example during the winter, follow the storage recommendations below:
• Be sure to disconnect the power supply after use.
• Store the power supply, cable, and cleaner with the caddy if included
with the cleaner.
• Store the cleaner in a protected area out of direct sun, rain and frost,
at a temperature between 5°-45°C / 41°-113°F.
• Drain all water from the pool cleaner.
• Thoroughly clean the filter baskets and filter screens and store the
cleaner with them installed.
STEP 5:
Remount the Impeller Cover
Gently push the impeller cover back onto the impeller
assembly. See Figure 34.
The tabs on the motor unit will lock the cover into place.
Figure 34
STEP 6:
Remount the Intermediate Cover and Manifold
Assembly
Reseat the intermediate cover and manifold assembly and
reinstall the two screws that hold the cover and manifold
assembly in place. See Figure 35.
2
1
3
Figure 35