To Next PageTo Next PageWhy is my Pentair Water Pump motor running but not pumping water?
If your Pentair Water Pump motor runs but the pump isn't moving liquid, the issue might be that the pump is sucking air. Check the joints to ensure they are leak-proof, verify that liquid levels haven't dropped below the foot valve, and confirm the foot valve is unblocked and also leak-proof.
What to do if my Pentair MAX is not running?
If the Pentair Water Pump isn't running, first ensure it's getting power by checking the plug and verifying the green LED is lit. If there's power, a red LED indicates a failure, possibly due to lack of water; identify the cause and press the restart button. Also, the pump might be stalled; in that case, identify the cause and unblock it. If these steps don't resolve the issue, the FLUSSCONTROLL may be faulty.
Why doesn't my Pentair Water Pump stop running?
If your Pentair Water Pump doesn't stop, it could be due to a blocked reset button. Inspect the pump and clean it if necessary. Another potential cause is the pump sucking in air. If these steps don't resolve the issue, the FLUSSCONTROLL may be faulty.
What to do if Pentair Water Pump stops after running for a short time?
If your Pentair Water Pump stops shortly after starting due to a thermal motor circuit breaker tripping, check that the power supply matches the nameplate data by checking the voltage on the power supply cable leads. If the power supply is correct, there might be a solid object blocking the impellers.
General| Brand | Pentair |
|---|---|
| Model | MAX Series |
| Category | Water Pump |
| Language | English |
