Pentair MiniMax NT/TSI 200 - Installation - Remote Hook-Ups (2 and 3 Wire)

P/N 472235 Rev. B 1-22-04
10
Installation (Remotes)
Figure 5.
Figure 6.
SPA COM POOL TPROBE
OUT RETURN
24 VAC
HILMT
IGNITION MOD
EXT SWITCH
THERMOSTAT CIRCUIT BOARD
JUMPER REQUIRED IF NO 2 WIRE REMOTE SWITCH
POOL/OFF/SPA
FRONT PANEL
THERMOSTAT SELECT SWITCH
TFUSE VALVE
PRESS
SPA COM POOL TPROBE
OUT RETURN
24 VAC
HILMT
IGNITION MOD
EXT SWITCH
THERMOSTAT CIRCUIT BOARD
JUMPER REQUIRED IF NO 2 WIRE REMOTE SWITCH
POOL/
OFF/SPA
FRONT PANEL
THERMOSTAT SELECT SWITCH
TFUSE VALVE
REMOTE POOL/OFF/SPA
THERMOSTAT SELECT SWITCH
PRESS
NOTE: When connecting a remote control to the MiniMax NT/TSI Heater, you must install the low
voltage thermostat wires in separate conduit isolated from ANY line voltage wires. Failure to
follow these instructions will cause the thermostat relay to react erratically..
REMOTE SWITCH DUAL THERMOSTAT
3 Wire Remote
2 Wire Remote