Pentair MiniMax NT/TSI 200 - Page 20

P/N 472235 Rev. B 1-22-04
20
.oNtcudorP.aiDtneV
605064.ni4
705064.ni5
Installation (Indoor)
CAUTION
Chemicals should not be stored near the heater
installation. Combustion air can be contaminated by
corrosive chemical fumes which can void the warranty.
VENT ADAPTORS
(FITS ALL MODELS)
The proper vent adapter must be installed on the heater
as shown below in Figure 15.
Vent
Adaptor
Table 2.
rofaerAnepoeerFteN
)sehcnIerauqS(*gninepOhcaE
retaeH
eziS
morfdetcuD
edistuO
morftceriD
edistuO
00200105
05252136
00305157
004002001
*
roolftaeno;sgninepoowtfoenorofsidetacidniaerA
.gniliecehttaenodnalevel
:ETON ,sgninepoepytneercsroepytderevuolgnisufI
roftcerrocotsrerutcafunaMneercS/revuoLhtiwkcehc
.ecnatsiserneercS/revuoLeht
COMBUSTION AIR SUPPLY
For indoor installation, the heater location must
provide sufficient air supply for proper combustion
and ventilation of the surrounding area.
The requirements for the air supply specify that the
room in which a heater is installed should be provided
with two permanent air supply openings; one within
12 inches of the ceiling, the other within 12 inches of
the floor.
These openings shall directly, or through duct, connect
to outdoor air.
Pentair Pool Products, Inc. does not recommend
indoor installations that do not provide combustion
air from outside the building.
Air Supply Requirements Guide
for MiniMax NT/TSI Heaters
Figure 15.