Pentair PROWLER 930 - Maintenance Procedures (Screens); Periodic Filter Screen Cleaning

PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User’s Guide
English
10
Periodic Filter Screen Cleaning
Note: It is recommended that you clean the lter screens at least once a month. Too much debris in the lter
screens will restrict the suction power of the Prowler™ 930 Robotic Pool Cleaner and reduce its effectiveness.
To dismantle and clean the four lter screens, follow the instructions given below.
STEP 1:
Empty the Inner and Outer Filter Baskets.
Follow steps 1-5 on the previous page. The inner and
outer lter baskets should be emptied and rinsed clean
before removing the outer basket’s lter screens.
STEP 2:
Remove the Filter Screen
Using your thumbs, rmly press inwards on the top of
Panel 1 to remove the lter screen from its frame.
See Figure 25.
Each lter screen is stamped with a number. see Figure 26.
Remove the lter screens in numerical order:
Screen 1 > 2 > 3 > 4.
Figure 25
Figure 26
STEP 3:
Clean the Filter Screens
Thoroughly clean the lter screen with a garden hose.
See Figure 27.
Figure 27
STEP 4:
Reassemble the Filter Screens
Replace the lter screens by seating the bottom of the
screen into its frame, then pushing rmly outwards on
the top of the screen until a click is heard.
Each lter screen is stamped with a number. See Figure
28. Replace the filter screens in numerical order:
Screen 4 > 3 > 2 > 1.
Figure 28
MAINTENANCE