Pentair PROWLER 930 - Caddy Assembly Procedure (Continued); Caddy Assembly: Handle and Power Supply Clip; Caddy Assembly: Power Cable Holder Attachment

PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User’s Guide
EnglishEnglish
5
PREPARATION OF THE POOL AND CLEANER
STEP 5:
Install the Caddy Handle
1. Insert the caddy handle into the handle support.
See Figure 12 .
2. Push the handle into it’s support as far as possible.
Figure 12
STEP 6:
Install the Power Supply Clip
3. Using the two longer Phillips-head screws, two
washers and two 8 mm (5/16”) nuts provided with the
caddy, install the power supply hook to the caddy’s
handle support. See Figure 13.
Figure 13
STEP 7:
Install the Power Cable Holder
1. Using the final two shorter Phillips-head screws
provided with the caddy, secure the power cable
holder to the caddy handle. See Figure 14 .
Figure 14
STEP 8:
Attach the Power Supply to the Caddy
1. Hook the power supply’s handle over the top lip of the
power supply clip. See Figure 15 (A).
2. Tilt the power supply toward the handle support until
the power supply snaps into place on the bottom lip
of the power supply clip. See Figure 15 (B).
Figure 15