Pentair PROWLER 930W - Cleaning Modes Explained; Schedule Cleaning Cycles

PENTAIR HOME for PROWLER® 930W Robotic Inground Pool Cleaner User's Guide
5
CleaningModes
The Prowler 930W features two cleaning modes FloorOnly and Regular.
FloorOnly: A 1-hour cleaning cycle that cleans the pool oor only. The cleaner will not climb and
clean walls or the waterline during when in this cleaning mode.
Regular(Floor,WallandWaterline): A 2-hour cleaning cycle that cleans the pool oor, walls and
waterline.
ProgrammingaCleaningSchedule
Tapping the Schedule tab, at the bottom of the
Prowler Dashboard, will display the Schedule
Setup screen.
This screen will allow you to program a new, or
edit an existing, automatic cleaning schedule.
ToProgramaCleaningSchedule:
1. Ensure the Status Toggle (1) is set to
ENABLED.
2. Set the desired Cleaning Mode by tapping
the highlighted Mode Description (2).
Choose between FLOOR ONLY and
REGULAR. Refer to Cleaning Modes
above for a explanation of each mode.
3. Set a Start Time (3).
The cleaner will begin its scheduled
cleaning cycles at the set time
4. Select how often your cleaner will run an
automatic cleaning cycle throughout the
week (4).
• 1 DAY = cleaner will cycle once a day
• 2 DAYS = cleaner will cycle every 2 Days
• 3 DAYS = cleaner will cycle every 3 Days
5. Tap the REPEAT EVERY WEEK Toggle (5)
to allow the programmed schedule to run
every week.
6. Tap SAVE (6) to save the programmed
schedule.
6
1
2
3
4
5
FIGURE10