Why are the rear wheels dragging/not spinning on my Pentair Swimming Pool Vacuum?
To address rear wheels dragging or not spinning on your Pentair Swimming Pool Vacuum, ensure the wheel sleeve is free of tangled debris. You may need to remove the wheel to remove any tangled debris.
Why is my Pentair Swimming Pool Vacuum booster pump very noisy?
If your Pentair Swimming Pool Vacuum's booster pump is very noisy, ensure that both the filter pump and booster pump are on and moving water. Cleaning your pool filter system may be necessary. Also, ensure the wall fitting is properly installed. If it's leaking, the O-ring may need replacement. It could also be a booster pump issue, so contact your local pool professional.
What to do if rear wheels are falling off Pentair Swimming Pool Vacuum?
Replace the wheel and wheel sleeve.
Why Pentair RACER Night Cruize LEDs are not illuminated?
If the Night Cruize LEDs on your Pentair Swimming Pool Vacuum aren't lighting up during operation, it might be due to debris clogging the generator turbine. To resolve this, remove the left rear wheel to find the access hole. Insert a large paper clip about 2 inches into the hole until you feel the generator turbine paddle. Rotate the paddle several times with the paper clip to clear any debris.
Why Pentair RACER hoses tangling in loops?
If your Pentair Swimming Pool Vacuum hoses are tangling in loops, check the length of the feed hose; if it's too long, it may cause tangling. Ensure the feed hose floats on the pool surface with hose floats spaced about two feet apart. Make sure the hose swivels spin freely, replacing them if they're tight, and check that the feed hose has no kinks or bends.
General| Type | Robotic |
|---|---|
| Pool Type | In-ground |
| Remote Control | No |
| Warranty | 2 years |
| Compatibility | All pool surfaces |
| Cable Length | 60 feet |
| Features | energy efficient |
| Cleaning Cycle | 2.5 hours |
Guidance on preparing for cleaner installation, including pool surface checks.
A list of essential checks and preparations before installing the pool cleaner.
Step-by-step guide for attaching the wall fitting and adapter.
Procedure for adjusting water flow using the flow gauge and wall fitting.
Steps for attaching the hose and debris bag to the cleaner head.
To Next Page