Pentair ULTRATEMP 70 - CUSTOMER SERVICE; TECHNICAL SUPPORT; Contact Information

ULTRATEMP
®
Heat Pump Installation and User’s Guide
ENGLISH
ESPAÑOL
FRANÇAIS
ii
If you have questions about ordering Pentair replacement parts, and pool products, please use the following
contact information:
CUSTOMER SERVICE / TECHNICAL SUPPORT
Customer Service
(8 A.M. to 4:30 P.M. — Eastern and Pacific Times)
Phone: (800) 831-7133
Fax: (800) 284-4151
Web site
Visit www.pentair.com for more information about
Pentair products.
Technical Support
Sanford, North Carolina (8 A.M. to 4:30 P.M. ET)
Phone: (919) 566-8000
Fax: (919) 566-8920
Moorpark, California (8 A.M. to 4:30 P.M. PT)
Phone: (805) 553-5000 (Ext. 5591)
Fax: (805) 553-5515
TABLE OF CONTENTS
Important Warning and Safety Instructions .......
Menu Tree Quick Start Guide ...............................
Before Installing the Heat Pump .........................
Heat Pump Overview
Installation Requirements
General Installation Information
General Features
Installation and Location .....................................
Materials Needed for Installation
Equipment Pad
Drainage and Condensation, Roof Run Off,
and Lawn Sprinklers
Heat Pump Dimensions
Location and Clearances
Anchor Clamp Installation
Water Connections and Plumbing
Automatic Flow Control Valve
Water Connections to the Heat Pump
Drainage Connection to the Heat Pump
Water Pressure Switch Adjustment
Multiple Unit Installation
Heat Pump, Heater, Solar Combination
Multiple Heat Pump Connections
Electrical Connections and Wiring
Wiring Diagram – (Single Phase – 50/60 Hz)
Wiring Diagram – (Three Phase – 60 Hz)
Connecting to an Automation System ...............
Remote Operation
Relay Remote Controls
Connecting to IntelliTouch or EasyTouch via
Heat Pump Spade Terminals
Connecting to IntelliTouch or EasyTouch via
RS-485 Connector
Pin Configuration for Heat Pump Control
Board to IntelliTouch
Connecting IntelliTouch or EasyTouch to
the Heat Pump
i
iii
1
1
1
1
1
2
2
2
2
2
3
3
4
4
5
5
6
7
7
7
9
10
11
12
12
12
13
14
15
15
For pool energy saving tips, refer to page 16, under “Operating the Heat Pump”. For technical data, voltage
requirements, or ambient/water flow information, refer to page 25 at the back of the manual.
Operating the Heat Pump ...................................
Swimming Pool Energy Saving Tips
Heat Pump Control Panel Overview
Operator Menu Tree Guide
Starting and Stopping the Heat Pump
Changing the Set Point - Pool and Spa
Heat, Cool, and Auto Modes
Heat Pump Timer
Relay Remote
RS-485 Remote (Serial Cable)
AutoSet Operation
Extend Operation
Timers and Delays
Control Panel Alarm Messages
Service Menu Tree Guide
Setting Temperature Scale
Set Water Temperature Offset
Defrost Cycle
Run Time Counters
Locking the Control Panel
Maintenance .........................................................
Water Chemistry
Winterizing
Spring Start Up
Inspection and Service
Owner Inspection
Professional Maintenance and Service
Technical Information .........................................
Electrical Supply - Voltage Requirements
Temperature Resistance Chart
Ambient/Water Flow Table for Professional
Maintenance and Service
Heat Pump Pressure Drop
Troubleshooting ...................................................
Replacement Parts ..............................................
Illustrated Parts View
Parts List
16
16
16
17
18
18
18
18
18
18
19
19
20
20
21
22
22
22
22
22
23
23
23
23
23
24
24
25
25
25
26
26
27
32
32
33