21
English
Automatic Flash Emission
When the shutter release button is depressed halfway
down in low light, the flash is automatically charged and
the green lamp lights up and () will appear to ( ) on
the LCD panel indicating the flash is ready to discharge.
• The automatic flash emission is set automatically when
the main switch is ON.
Flash effective ranges (Color negative film used)
ISO
100 400
Lens
38mm ( )
0.8-3.9m 0.8-7.9m
(2.6-13ft) (2.6-26ft)
115mm ( )
0.8-1.4m 0.8-2.8m
(2.6-4.6ft) (2.6-9.2ft)
1. Rewinding the film (Fig. 9-1)
After you have exposed the last frame of the roll, the
lens retracts and the film rewinds automatically.
Then, the motor stops, and ( ) blinks for approx. 5
seconds to indicate that the film has been rewound
completely.
And the power will turn OFF automatically.
• If you turn the main switch ON before removing the
film, ( ) blinks and the shutter cannot be released.
2. Unloading film (Fig. 9-2)
Open the back cover, and remove the film cartridge
from the chamber by pulling the top out first with your
finger.
Notes:
• Never open the back cover until the whole film roll is
rewound completely.
• A 24-exposure roll of film takes about 20 seconds to be
rewound.
• The shutter may be released one or two frames even
after the specified number of frames have been used
up as indicated by the number of shots shown on the
film cartridge. If this occurs, these extra frames may be
lost in processing.
UNLOADING FILM
To Next Page
Loading...
Need help?
General
