24
Turn the main switch ON to set this mode. (Fig. 12)
In this mode, the camera controls exposures automati-
cally for bright and dark condition with automatic flash
emission.
Depress the Flash mode button until ( ) appears on
the LCD panel. (Fig. 13)
Same as 1. Auto mode, with automatic flash emission
and the red-eye reduction flash.
Depress the Flash mode button to set the arrow mark on
the LCD panel to ( ). (Fig. 14)
In this mode, the flash will discharge in both dark and
bright conditions. When a portrait is taken with the sub-
ject in a backlight situation, the front of the subject may
be cast in shadow. In such a case, use the Daylight-sync
shooting mode (Flash-ON) within the flash effective
range to take pictures. This will ensure that a subject is
well exposed without any shadow. When you wish to dis-
charge the flash as a fill-in, use this mode. In this mode,
the flash will always discharge.
Note:
• Make sure you’re within the flash effective range even
when you use the built-in flash as a fill-in flash in daylight.
3.
AUTO MODE/ DAYLIGHT-SYNC (FLASH ON)
2. AUTO MODE/
red-eye reduction flash
1. AUTO MODE
To set various shooting modes, depress the Self-
timer/AF infinity-landscape button w.
• For normal use, use the Single-Frame Shooting Mode.
Red-Eye Reduction Flash Function
To reduce the red-eye phenomenon in the picture,
depress the flash mode button until ( ) appears. With
this mode, the self-timer lamp lights up for approx.1 sec-
ond just before the flash is discharged to reduce the
appearance of the red-eye effect. To cancel this mode,
depress the flash mode button to set to auto mode.
To Next Page
Loading...
