15
English
If you purchased the DATE model, read this section.
Notes:
• The data on the LCD panel will be imprinted on the film.
• “----” indicates no data will be imprinted.
• “M” on the LCD panel indicates “Month”.
• The DATE model records dates up to the year 2049 on
pictures.
Switching the Mode
Depress the DATE button q with your finger, the mode
on the LCD panel switches as shown in the chart.
DATE MODEL
Correcting the date
Use the strap clamp’s protrusion to depress the
SELECT and ADJUST buttons.
1. To select the category of digits that you want to
change, depress the SELECT button w repeated-
ly until the digits on the LCD panel that wish to
change begin to blink.
2. Depress the ADJUST button e to change digits of
the specified category you chose with the
SELECT button w. Digits increase by one each
time you depress the ADJUST button e. Holding
down the button will advance digits continuously.
3. After the data has been adjusted, depress the
SELECT button w. The bar mark ( - ) appears on
the LCD panel, indicating that data imprinting
choices are possible.
• The blinking “ : ” allows precise fine-tuning of the inter-
nal clock to the beginning of a specified minute. To do
so, depress the DATE button q until “Day-Hour-
Minute” digits appear and then depress the SELECT
button w to make the “ : ” blink. Then depress the
ADJUST button e in sync with a time signal.
• If you release the shutter while the blinking data is
being corrected, the data cannot be imprinted.
To Next Page
Loading...
Need help?
General
