Appendix 1 Default radio configuration
The frequency and protocol of the 8 channels could be modified via Web UI or
controller. So you could change it easily. And the Frequency range is from 410MHz to
470MHz, so you can elect as you want.
Appendix 2 Voice messages
It will broadcast “rover” if the current Working mode is rover.
It will broadcast “base” if the current Working mode is base.
It will broadcast “static” if the current Working mode is static.
It will broadcast when the Solution change to single.
It will broadcast when the Solution change to RTD.
It will broadcast when the Solution change to Float.
It will broadcast when the Solution change to fixed.
It will broadcast when the self-check successful.
It will broadcast when power off the receiver.
It will broadcast when receiver start record data in static.
To Next Page
Loading...