Pentax MV-1 User Manual

FILM LOADING AND WINDING
Avoid direct light when loading your film.
1 Before loading and winding the film, set the exposure mode dial
to 100X. Leave it at this setting until after the film has been wound
to the first exposure.
Note: You may also advance the film to the first exposure with the
exposure mode dial set to AUTO. But, in this case, after closing the
back cover, you must remove the lens cap and point the camera
toward the light. If film advance is performed on AUTO without
removing the lens cap, inor¬
dinately long exposures will
result, hindering film advance.
2 Open the camera back by
pulling up the film rewind knob
until the back opens.
3. Place the film cartridge in
the film chamber, and push
down the rewind knob. Insert
the film leader between any
of the white pins surrounding
the film take-up spool.
Advance the film by
alternately advancing the rapid-
wind lever and depressing the
shutter button until both top
and bottom sprockets engage
the film perforations Q .
Close the back by pressing it
firmly.
> Advance the rapid-wind
lever and confirm that the film
rewind knob 0 turns
counterclockwise, indicating
10 *

Pentax MV-1 Specifications

General

Brand	Pentax
Model	MV-1
Category	Digital Camera
Language	English