CAMERA OPERATION
49
STEP UP
ADVANCED OPERATIONS
SELF-TIMER MODE
After you pressing the shutter release button, the picture
will be taken about 12 sec. later. Use the self-timer when
you want to be in the picture.
1 Setting the self-timer mode
qTurn the main switch to ON.
wPress the drive mode button until [ ]
appears on the LCD panel.
Preventing stray light from entering the eyepiece
Underexposure may occur if light enters the viewfinder during self-timer
operation on auto picture mode and 6 picture modes. If you intend to
move away from the viewfinder, attach the supplied finder cap or use
AE lock function ( p.73).
Detaching Eyecup Attaching the finder cap
2 Using the self-timer mode
qDepress the shutter release button
halfway down to focus the subject.
48
1 Setting the multi-exposure mode
q Turn the main switch to ON.
wPress the drive mode button until [ ]
appears on the LCD panel.
The frame counter will blink.
2 Using the multi-exposure mode
q Take the first picture.
The frame counter and [ ] on the
LCD panel blink.
w Take the second picture.
The frame counter stops blinking
and film is advanced to next frame
then return to single frame drive
mode [ ].
To exposed the third shot or more,
press the drive button until []
appears after repeating step 1.
The multi-exposure mode remains in
effect even after the main switch is
turned [OFF]. To cancel the multi-expo-
sure mode, remove the batteries once
and load again.
To Next Page
Loading...
