CAMERA OPERATION
wDepress the shutter release button
completely.
The shutter will be released about 12
seconds after the shutter release but-
ton is depressed. The audible PCV sig-
nal is heard and the rate increases for
the last two seconds.
3 Cancelling the self-timer mode
qPress the drive mode button to
another setting.
The self-timer mode is cancelled.
The stop the self-timer operation after it
has been activated, press the drive
mode button again.
The audible PCV signal can be stopped
( p.74).
REMOTE CONTROL SHOOTING (OPTIONAL)
If you have purchased the optional wireless remote
control, read this section.
The shutter will be released 3 seconds after the remote
control's shutter release button is pressed.
qAttach the camera to a tripod.
51
w Press the drive mode button until
[ ] appears on the LCD panel.
e The self-timer lamp starts blinking
slowly.
r Aim the remote control transmitter
towards the remote control receiver
on the camera, and then press the
shutter release button on the
remote control.
t The self-timer lamp blinks rapidly
for 3 seconds and then the shutter
is released.
y When the picture is taken, the
self-timer lamp lights for approx.
2 seconds and return to blink slowly.
STEP UP
ADVANCED OPERATIONS
50
MZ-6(E)04 D1/045-073 11/8/02 12:00 PM Page 50
To Next Page
Loading...
