69
6 When the shutter release button
is depressed halfway down, the
shutter speed and aperture value
will be displayed in the viewfind-
er and on the LCD panel.
7 When under or over exposure is
set beyond + 2 or - 2 steps (2EV),
[ ] or [ ] indicator will blink.
• The bar underneath the shutter speed
indicates that you can change the shut-
ter speed. With the exposure compen-
sation button pressed, the bar appears
underneath the aperture that indicates
you can change the aperture value.
• The AE lock and exposure compensa-
tion do not work in the Metered Manual
Mode.
• The metered manual mode can be used
even if the aperture ring is not set to “A”.
Turn the lens aperture ring to select the
desired aperture ring. Since the indica-
tion of aperture value inside the
viewfinder only serves as a general ref-
erence, it may differ from the set aper-
ture value.
STEP UP
ADVANCED OPERATIONS
68
2 Set the mode dial to [M].
3 Move the select switch to
change the shutter speed.
4 Move the select switch to
change the aperture while hold-
ing the exposure compensation
button.
5 The dot displayed in the center
of the bar graph indicates the
correct exposure.
Moving one dot on the bar graph
indicates 0.5 step (0.5EV).
SELECTING AN EXPOSURE MODE
MZ-6(E)04 D1/045-073 11/8/02 12:01 PM Page 68
To Next Page
Loading...
Need help?
General
