Local Service Firewall Settings
This setting specifies a name for the firewall rule.
This setting specifies whether the firewall rule should take effect.
If the box is checked, the firewall rule takes effect. If the traffic matches the specified
protocol/IP/port, actions will be taken by Peplink Balance based on the other parameters of
the rule.
If the box is not checked, the firewall rule does not take effect. The Peplink Balance will
disregard the other parameters of the rule.
Click the dropdown menu next to the checkbox to place this firewall rule on a time
schedule.
This option allows you to define the supported local service to be matched.
If Any is chosen, the firewall rule will match to all supported local services from the list.
Via a drop-down menu, the following services can be specified:
● Any
● SpeedFusion / PepVPN Handshake
● SpeedFusion / PepVPN Data Port
● Web Admin Access
● DNS Server
● SNMP Server
● KVM Management Port
● KVM VNC Port
● FusionSIM Agent / Remote SIM Proxy
Select the WAN connection that this firewall rule should apply to.
This specifies the source IP address and IP Network to be matched for the firewall rule.
With the value of Allow for the Action setting, the matching traffic passes through the
router (to be routed to the destination). If the value of the Action setting is set to Deny, the
matching traffic does not pass through the router (and is discarded).
To Next Page
Loading...
Need help?
General
