peplink B One Series - Page 192

Name
SNMP Port
This option specifies the port which SNMP will use. The default port is 161.
SNMPv1
This option allows you to enable SNMP version 1.
SNMPv2
This option allows you to enable SNMP version 2.
SNMPv3
This option allows you to enable SNMP version 3.
SNMP Trap
This option allows you to enable SNMP Trap. If enabled, the following entry fields
will appear.
SNMP Trap
Community
This setting specifies the SNMP Trap community name.
SNMP Trap
Server
Enter the IP address of the SNMP Trap server.
SNMP Trap Port
This option specifies the port which the SNMP Trap server will use. The default
port is 162.
SNMP Trap
Server Heartbeat
This option allows you to enable and configure the heartbeat interval for the SNMP
Trap server.
To add a community for either SNMPv1 or SNMPv2, click the Add SNMP Community button in
the Community Name table, upon which the following screen is displayed:
SNMP Community Settings
Community
Name
This setting specifies the SNMP community name.
Allowed Source
Subnet Address
This setting specifies a subnet from which access to the SNMP server is allowed.
Enter subnet address here (e.g., 192.168.1.0) and select the appropriate subnet
mask.
https://www.peplink.com
192
Copyright @ 2024 Peplink