peplink B One Series - Page 193

To define a user name for SNMPv3, click Add SNMP User in the SNMPv3 User Name table,
upon which the following screen is displayed:
SNMPv3 User Settings
User Name
This setting specifies a user name to be used in SNMPv3.
Authentication
Protocol
This setting specifies via a drop-down menu one of the following valid
authentication protocols:
● NONE
● MD5
● SHA
When MD5 or SHA is selected, an entry field will appear for the password.
Privacy Protocol
This setting specifies via a drop-down menu one of the following valid privacy
protocols:
● NONE
● DES
When DES is selected, an entry field will appear for the password.
23.8 SMS Control
SMS Control allows the user to control the device using SMS even if the modem does not have
a data connection. The settings for configuring the SMS Control can be found at System > SMS
Control.
Supported Models
● Balance/MAX: *-LTE-E, *-LTEA-W, *-LTEA-P, *-LTE-MX
● EPX: *-LW*, *-LP*
https://www.peplink.com
193
Copyright @ 2024 Peplink