minutes without any action.
This can be used when testing the SpeedFusion VPN’s speed between two locations to see if
there is interference or network congestion between certain WAN connections.
The SpeedFusion VPN test configuration allows us to configure and perform thorough tests.
This is usually done after the initial installation of the routers and in case there are problems
with aggregation.
Press the Start button to perform throughput test according to the configured options.
If TCP is selected, 4 parallel streams will be generated to get the optimal results by default. This
can be customized by selecting a different value of streams.
Using more streams will typically get better results if the latency of the tunnel is high.
To Next Page
Loading...
Need help?
General
