If “Alternate between SIM A and SIM B periodically” is selected, the SIM card will
be switching according to the schedule time in the SIM Cards Alternate.
If “Custom Selection” is selected, you can designate the priority of the SIM cards
(SIM A/ SIM B/ Remote SIM/ SpeedFusion Connect) and connect to.
For routers that support the SIM Injector, you may select the “Remote SIM” to
provision a SIM from a SIM Injector. Further details on the SIM Injector found is
available here: https://www.peplink.com/products/sim-injector/.
If “Use Remote SIM Only” is selected in the SIM card section, the Remote SIM
Settings will be shown.
You may need to enable the remote SIM Host settings in the Remote SIM
management, see the section 22.10 or Appendix B for more details on FusionSIM.
After that, click on “Scan nearby remote SIM server” to show the serial number(s)
of the connected SIM Injector(s).
If you want to select a specific SIM, in the Cellular Settings, type “:” and then the
number of the SIM slot, eg.1111-2222-3333:7.
Fallback to
Prefered SIM
when
This option is allowing to switch to another SIM cards when the Cellular WAN
reached faillback timeout.
If “Alternate between SIM A and SIM B periodically” is selected in the SIM Card
section, the SIM Cards Alternate will be shown:
You may set the schedule time for for switching between SIM A only and SIM B only.
This drop-down menu allows restricting cellular to particular band. Click the
button to enable the selection of specific bands.
Cellular WANs by default will only handover from 3G to LTE network when there is
no active data traffic, enable this option will make it run the handover procedures
after fallback to 3G for a defined effective period, even this may interrupt the
connectivity for a short while.
When set to Auto, band selection allows for automatically connecting to available,
supported bands (frequencies) .
To Next Page
Loading...
Need help?
General
