peplink Balance 380 - Pppoe Connection; Server Name

USER MANUAL
Peplink Balance Series
http://www.peplink.com -99 / 261 - Copyright © 2015 Peplink
12.2.3 PPPoE Connection
This connection method is suitable if your ISP provides a login ID/password to connect
via PPPoE.
PPPoE Settings
PPPoE User
Name /
Password
Enter the required information in these fields in order to connect via PPPoE to your ISP.
The parameter values are determined by and can be obtained from your ISP.
Confirm PPPoE
Password
Verify your password by entering it again in this field.
Server Name
(Optional)
Server name is a PPPoE parameter which is provided by your ISP.
Note: Leave this field blank unless it is provided by your ISP.
IP Address
PPPoE server address is a parameter which is provided by your ISP.
Note: Leave this field blank unless it is provided by your ISP.
DNS Servers
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies the
DNS (Domain Name System) servers to be used when a DNS lookup is routed through this
connection.
Selecting Obtain DNS server address automatically results in the DNS servers assigned
by the PPPoE server to be used for outbound DNS lookups over the WAN connection.
(The DNS servers are obtained along with the WAN IP address assigned from the PPPoE
server.)
When Use the following DNS server address(es) is selected, you can enter custom DNS
server addresses for this WAN connection into the DNS server 1 and DNS server 2 fields.
Please refer to Sections 0, 12.3, 12.4, and 12.5 for details about WAN Health Check,
Bandwidth Allowance Monitor, Additional Public IP Settings, and Dynamic DNS
Settings.
Note
A PPPoE connection made from a firewall does not work with drop-in mode.