NAT allows substituting the real address in a packet with a mapped address that is
routable on the destination network. By clicking the help icon in this field, you can
display the IP Forwarding option, if your network requires it.
Enter the required information in these fields in order to connect via L2TP to your
ISP.
The parameter values are determined by and can be obtained from your ISP.
Verify your password by entering it again in this field.
L2TP server address is a parameter which is provided by your ISP.
Note: Leave this field blank unless it is provided by your ISP .
Your ISP will also indicate whether the server IP address is Dynamic or Static.
Please click the appropriate value.
Each ISP may provide a set of DNS servers for DNS lookups. This setting
specifies the DNS (Domain Name System) servers to be used when a DNS lookup
is routed through this connection.
Selecting Obtain DNS server address automatically results in the DNS servers
assigned by the PPPoE server to be used for outbound DNS lookups over the
WAN connection.
(The DNS servers are obtained along with the WAN IP address assigned from the
PPPoE server.)
When Use the following DNS server address(es) is selected, you can enter
custom DNS server addresses for this WAN connection into the DNS server 1
and DNS server 2 fields.
To Next Page
Loading...
Need help?
General
