of the SIM card slots here.
If “ Use Remote SIM Only ” is selected in the SIM card section, the Remote SIM
Settings will be shown.
You may need to enable the remote SIM Host settings in the Remote SIM
management, see the section 22.10 or Appendix B for more details on FusionSIM.
After that, click on “ Scan nearby remote SIM server ” to show the serial number(s)
of the connected SIM Injector(s).
If you want to select a specific SIM, in the Cellular Settings, type “ : ” and then the
number of the SIM slot, eg.1111-2222-3333:7.
This drop-down menu allows restricting cellular to particular band. Click the
button to enable the selection of specific bands.
Optimal
Network
Discovery
Cellular WANs by default will only handover from 3G to LTE network when there is
no active data traffic, enable this option will make it run the handover procedures
after fallback to 3G for a defined effective period, even this may interrupt the
connectivity for a short while.
When set to Auto , band selection allows for automatically connecting to available,
supported bands (frequencies) .
When set to Manual, you can manually select the bands (frequencies) the SIM will
connect to.
This checkbox enables data roaming on this particular SIM card. When data roaming
is enabled this option allows you to select in which countries the SIM has a data
connection. The option is configured by using MMC (country) codes.Please check
your service provider’s data roaming policy before proceeding.
Choose from PAP Only or CHAP Only to use those authentication methods
exclusively. Select Auto to automatically choose an authentication method.
This setting allows you to configure the APN settings of your connection. If Auto is
selected, the mobile operator should be detected automatically. The connected
device will be configured and connection will be made automatically. If there is any
difficulty in making connection, you may select Custom to enter your carrier’s APN ,
Login , Password , and Dial Number settings manually. The correct values can be
obtained from your carrier. The default and recommended setting is Auto .
To Next Page
Loading...
Need help?
General
