This field is for setting the wait time to receive an acknowledgement packet
before performing a retransmission. By default, this field is set to 48 µs .
This option allows you to enable frame aggregation to increase transmission
throughput.
A
- Advanced feature, please click the button on the top right-hand corner to activate.
Web Administration Settings
Ticking this box enables web admin access for APs located on the WAN.
Determines whether the web admin portal can be accessed through HTTP or
HTTPS
Determines the port at which the management UI can be accessed.
Determines the username to be used for logging into the web admin portal
Determines the password for the web admin portal on external AP.
Wi-Fi WAN settings can be configured at Advanced>Wi-Fi Settings (or Advanced>Wi-Fi WAN
or some models).
Available options are 20/40 MHz and 20 MHz . Default is 20/40 MHz, which
allows both widths to be used simultaneously.
This option allows you to select a specific bit rate for data transfer over the
device’s Wi-Fi network. By default, Auto is selected.
This option is for specifying the transmission output power for the Wi-Fi AP.
There are 4 relative power levels available – Max , High , Mid , and Low . The
actual output power will be bound by the regulatory limits of the selected
country.
Note that selecting the Boost option may cause the MAX’s radio output to
exceed local regulatory limits.
To Next Page
Loading...
Need help?
General
