This field specifies the number of hours and minutes that a web session can
remain idle before the Pepwave router terminates its access to the web admin
interface. By default, it is set to 4 hours .
With this box is checked, the web admin will authenticate using an external
RADIUS server. Authenticated users are treated as either "admin" with full
read-write permission or “user” with read-only access. Local admin and user
accounts will be disabled. When the device is not able to communicate with the
external RADIUS server, local accounts will be enabled again for emergency
access. Additional authentication options will be available once this box is
checked.
This specifies the authentication protocol used. Available options are MS-CHAP
v2 and PAP .
This specifies the access address and port of the external RADIUS server.
This field is for entering the secret key for accessing the RADIUS server.
This option specifies the time value for authentication timeout.
This specifies the access address and port of the external accounting server.
This field is for entering the secret key for accessing the accounting server.
This option is for specifying the network connection to be used for
authentication. Users can choose from LAN, WAN, and VPN connections.
The CLI (command line interface) can be accessed via SSH. This field enables
CLI support. For additional information regarding CLI, please refer to Section
30.5.
This menu allows you to choose between granting access to LAN and WAN
clients, or to LAN clients only.
This field determines the port on which clients can access CLI SSH.
CLI SSH Access
Public Key
This field is for entering the Public Key for Admin Users and Read-only Users to
access CLI SSH.
This option is for specifying the protocol(s) through which the web admin
interface can be accessed:
● HTTP
● HTTPS
● HTTP/HTTPS
This field is for specifying the port number on which the web admin interface can
To Next Page
Loading...
Need help?
General
