2022-12
16
IDM-Z1-264-M-2D-J1-BT-N-N0, IDM-Z1-164-M-1D-J1-BT-P-N0
Commissioning
Figure 5.2 Removing the protective battery cap
3. The battery is inserted into the compartment on the handheld scanner. The end of the pull tab
must be seen protruding out of the opening of the handheld scanner. If the battery is inserted
correctly and connected to the contacts, there is an audible and visual signal. The opening
must be completely sealed again. Before commissioning, check whether the screw cap has
been properly sealed.
Figure 5.3 Inserting the battery and closing the protective cap
Danger!
The designated battery must only be used!
To Next Page
Loading...