IDM-Z1-264-M-2D-J1-BT-N-N0, IDM-Z1-164-M-1D-J1-BT-P-N0
Commissioning
2022-12
17
Using the base station in explosion-hazardous areas - system structure
1
1. Use the connection cable CBL-IDMx* to connect the base station to the supply module SK-
IDM-Z1*. First, install the RJ50 male connector of the connection cable into the RJ50 port of
the base station. The port is located on the bottom side of the base station. The connection
cable is properly installed when you can hear an acoustical click. Ensure that the connection
cable is firmly connected. Then proceed and connect the M12 connector of the connection
cable with the female M12 connector of the supply module base connection cable. This cable
is pre-installed and shipped with the supply module.
Figure 5.4 Connecting RJ50 connector of connection cable CBL-IDM* to base station
Figure 5.5 Male M12 connector of connection cable CBL-IDM*
To Next Page
Loading...