IDM-Z1-264-M-2D-J1-BT-N-N0, IDM-Z1-164-M-1D-J1-BT-P-N0
Commissioning
2022-12
15
5 Commissioning
5.1 Preparing Bluetooth® Handheld Scanners
Preparation of Bluetooth® handheld scanners
1. The battery compartment is located on the underside of the Bluetooth® handheld scanner.
Loosen the screw with a suitable tool to remove the cover. After loosening the screw, some
force is required to remove the cover.
Figure 5.1 Removing the battery compartment lid
2. The battery is required to commission the Bluetooth® handheld scanner. The protective cap
must be removed before inserting the battery into the handheld scanner.
Note
Charge the new battery pack for 8 hours prior to the first use.
Warning!
Self discharge of the batteries
When the batteries are inserted in the barcode reader, they tend to discharge more quickly.
This effect can also occur when the barcode reader is not in use and is in stand-by mode. If the
batteries are not inserted in the device, they discharge more slowly. If the batteries are inserted
in the scanner, i.e. in stand-by mode, it is recommended to charge them regularly.
Danger!
The battery must not be changed or inserted in explosion-hazardous areas. Improper handling
can void the type approval.
To Next Page
Loading...