KFU8-DW-1.D
Operation
129506 2012-12
17
Error message
1. Enter the parameters again.
2. Switch the device off and back on again.
The normal function of the output relay is restored.
5.2 Setup mode
See chapter 7.5
Function selection
2 measurement functions are available:
1. Frequency measurement in Hz
The established cycle duration of the input signal is converted
into a frequency in Hz through the formation of a reciprocal val-
ue and displayed. Specify the hysteresis limits of the switching
point in Hz as well.
2. Rotational speed measurement in rpm (factory preset)
Note!
If, when switching on again, the error message appears,
then the factory presets were loaded.
To Next Page
Loading...
