Pepwave MAX 700 User Manual

Pepwave MAX and Surf User Manual
http://www.pepwave.com 43 Copyright @ 2016 Pepwave
9 Configuring the LAN Interface(s)
9.1 Basic Settings
LAN interface settings are located at Network>LAN>Basic Settings. Navigating to that
page will result in the following dashboard:
This represents the LAN interfaces that are active on your router (including VLAN). A
grey “X” means that the VLAN is used in other settings and cannot be deleted. You can
find which settings are using the VLAN by hovering over the grey “X”.
Alternatively, a red “X” means that there are no settings using the VLAN. You can delete
that VLAN by clicking the red “X”
Clicking any of the existing LAN interfaces (or creating a new one) will result in the
following
IP Settings
IP Address
The IP address and subnet mask of the Pepwave router on the LAN.
Network Settings
Name
Enter a name for the LAN.
VLAN ID
Enter a number for your VLAN.
Inter-VLAN
routing
Check this box to enable routing between virtual LANs.

Pepwave MAX 700 Specifications

General

Brand	Pepwave
Model	MAX 700
Category	Wireless Router
Language	English