Pepwave Surf On-The-Go Quick Start Guide

Quick Start Guide
Pepwave Surf On-The-Go
The Ultimate Travel Router
Connecting to the Web Admin Interface
Getting Started
1
2
3
4
Antenna
Connect the antenna to the Surf On-The-Go by screwing the antenna
clockwise into the antenna jack.
Ethernet
When using Wi-Fi and Cellular modes, connect one end of an
Ethernet cable to the Surf On-The-Go’s LAN port and the other end to
your computer's Ethernet port. When using Wired mode, connect
one end of an Ethernet cable to the Surf On-The-Go’s LAN port and
the other end to your Internet source.
Power Adapter
Connect the power adapter to the Surf On-The-Go’s DC port, and then
plug the adapter into the nearest power outlet.
USB
Connect a USB modem to the Surf On-The-Go’s USB port when using
Cellular mode.
1 2 3 4
Connect to the Web Admin Interface wirelessly when using Wired Mode.
When using Wi-Fi and Cellular modes, connect to the Web Admin Interface using an Ethernet cable.
Open a web browser and enter the following URL: http://192.168.20.1.
When the Surf On-The-Go is connected to the Web Admin Interface, the Dashboard will be displayed.

Pepwave Surf On-The-Go Specifications

General

Model	Surf On-The-Go
Category	Network Router
WAN Ports	1
LAN Ports	1
Wireless Standards	802.11ac
Max Wireless Speed	433 Mbps
Frequency Band	2.4 GHz / 5 GHz
Ethernet Ports	1
Cellular Connectivity	4G LTE
SIM Slots	1
USB Port	1
Power Input	12V DC
Weight	0.4 lbs
Operating Temperature	0 to 40 °C