Pepwave Surf On-The-Go - Page 2

4G/3G USB
Modem
Local AP
& Ethernet
to Home PC / Laptop
Connect to the Web Admin Interface. Click
Cellular, and then Settings.
1
2
Click General Settings on the left. In the AP
Settings section, select Congure Manually. In
the AP SSID eld, enter the network name used
to identify the home Wi-Fi network. The default
AP SSID value, PEPWAVE_7505, is used in this
guide. To store your settings, click the Save
button that appears on the lower right.
Click Cellular Settings on the left. In general,
selecting Auto Operator Settings is sucient
to connect to the Internet. If not, select Custom
Operator Settings to manually enter settings
specied by your cellular service provider
(typically APN and Dial Number). When
nished, click Save on the lower right.
From the Authentication drop-down menu,
select WPA/WPA2-Personal. In the Encryption
Key eld, enter an authentication password of
at least 8 characters. Click Save to store your
changes.
Upon successful connection, all of the LEDs on
the Surf should be lit as follows:
PWR – Solid Green
RDY– Yellow
ENET– Solid Green
Wi-Fi – Displays a varying number of lit signal
bars depending on the strength of the received
signal
6
Navigate to the Dashboard page, which
displays connection details and signal strength
level.
5
3
4
Cellular Mode
Connect to the Internet using a 4G (WiMAX / LTE),
3G USB Modem, and provide a Local Access Point
and Ethernet Connection.
e.g. Traveler, Remote Area
A Cellular Mode Conguration